|
|
Set Up Instructions
1.
HOOK. Attach the yellow straps around or to a
support. The yellow straps have clip hooks on the ends that clip together to
form a loop or attach directly to a support object. Recommended supports are:
fences, luggage racks of vehicles, trees and eyebolts attached to walls or
structures. 2.
PULL. Pull out on the handle of the SportsShade
housing until the awning material is completely extended and can pull out no
further. SportsShade must be completely extended to be held in place by the
guy lines. 3. STAKE. Pull each guy line until it is fully extended at an approximate angle of 45 degrees from the support legs. Place the stake perpendicular to the ground and drive it into the soil until the collar is touching soil. Do not use stakes in sand or mostly sandy soil. It is recommended to use SportsShade weight bags (sold separately). Please note that Inventive Ideas is not responsible damage or injury cause by any modification made to the SportsShade. 4.
SWING. Prop up the awning into the tension of the
staked guy lines. Swing down on the legs, which are held horizontal by black
clips and swing them vertically into place. The legs should be perpendicular to
the housing for correct use. To Take SportsShade DownUse the 4 steps listed above
in reverse order. Windy Conditions:
During windy conditions it may be difficult getting the awning material to
retract due to a ballooning effect. In this case – try putting the housing on
the ground and let the awning go down into the housing or try to line the
housing and the awning up parallel to the wind direction and then retracting. Warnings:
-
Do not use in winds or gusts in excess of 25 mph.
-
Do not place grills or cooking devises beneath the shade.
-
Do not use during stormy weather.
-
Improper use may result in damage or injury.
-
SportsShade will not support snow loads. | |||||||||||||||||||||||||||||||||||